Install Guide
Overview
This app collects the syslog messages sent by SonicWall SMA (Secure Mobile Access) into Logpresso Sonar.
Scope
Note
App 1.1.2611.0 or later works with Sonar 4.0.2312.0 or later. Event and Logserver log classification is supported in app 1.1.2611.0 or later.
Requirements
| Item | Requirement | Note |
|---|---|---|
| Sonar permission | System administration permission | Access to Collect > Loggers |
| SMA permission | Permission to change the syslog settings | SMA management console administrator account |
| Network access | UDP/514 or TCP/514 (SonicWall SMA → Sonar collector node, inbound) | Apply the firewall policy |
SonicWall SMA Settings
In the log settings of the SonicWall SMA management console, set the Sonar collector node as the syslog server. The menu location and item names differ by series (SMA 100, SMA 1000) and firmware version, so refer to the administration guide of your appliance as well.
- Go to the log settings screen in the management console.
- Enter the IP address of the Sonar collector node as the syslog server address.
- Set the port and protocol to match what the Sonar logger receives (default UDP/514).
- Save the settings.
Logpresso Collection Settings
Go to Collect > Loggers, click Add, and enter the following values.
| Type | Item | Setting |
|---|---|---|
| Required | Name | A unique name that identifies the logger |
| Required | Storage location | Select the node that stores the logs |
| Optional | Collection location | Select the sentry that performs the collection |
| Required | Logger model | Select SonicWall SMA |
| Required | Table | A table name that starts with SSLVPN_SONICWALL. e.g. SSLVPN_SONICWALL |
| Optional | Remote IP | IP of SonicWall SMA. Supports a single IP, an IP1-IP2 range, and CIDR |
| Optional | Port | Receiving port filter. If empty, logs from all receiving ports are accepted |

